FABRICATION, CHARACTERIZATION, AND SYSTEM-LEVEL INTEGRATION OF A Cr/Ni MEMS THERMOPILE SENSOR ON A SUB-20-µm SUSPENDED MEMBRANE FOR GAS FLOW MONITORING

Main Article Content

NGUYEN TUAN ANH
HAN PHU KHANG
NGUYEN SI HOAI VU
TRAN DUY HOAI
NGUYEN THANH PHUONG
DAO MINH TUAN
HUYNH TRONG PHAT
TRUONG HUU LY
NGUYEN CHI CUONG
TRINH XUAN THANG

Abstract

This paper presents the fabrication, characterization, and system-level integration of a Micro-Electro-Mechanical Systems (MEMS) thermopile-based gas flow sensor fabricated on a sub-20-µm suspended membrane. The device comprises a central Ti/Ni microheater and two symmetric thermopiles, each containing 20 series-connected Cr/Ni thermocouple pairs, on a 17.57 ± 1.24 µm residual silicon membrane with an approximately 1.0 µm SiO2 isolation layer. Building on earlier membrane-thickness optimization, this study reports structural metrology, electrothermal characterization, differential flow sensing, signal conditioning, and embedded calibration of the fabricated device. Under zero-flow conditions, the upstream and downstream thermopiles exhibit closely matched Seebeck outputs. Nitrogen-flow characterization at a 5 V heater input yields single-ended cooling sensitivities of 9.83 and 8.19 µV/sccm, while an independently anti-series measurement gives a differential sensitivity of 2.21 ± 0.08 µV/sccm over 0–1100 sccm. The sensor was subsequently integrated into a standalone flow-metering prototype with signal amplification, analog-to-digital conversion, and microcontroller-based processing. A second-order polynomial was used to calibrate the nonlinear full-range response of the complete measurement chain. The prototype exhibited response and recovery times of 1.8 and 2.5 s, respectively, at 500-sccm-level. Independent validation over 0–1000 sccm produced an MAE of 27.18 sccm, an RMSE of 32.00 sccm, and a maximum full-scale error of 5.50%. Across repeated measurements, the coefficient of variation ranged from 3.87% to 8.59%. These results demonstrate a compact nitrogen-flow monitoring platform and identify ambient-temperature compensation and gas-specific calibration as priorities for further development.

Article Details

Section
Mechanical Technology, Energy